Did you try to delete the /etc/can.conf file? works for me

Hi Jeroen, indeed that helps.
Looks all normal now 🙂 i will test it later in the car

Hallo Jeroen, Ik testte de nieuwe versie met een nieuwe Pi.

Raspbian Stretch and Kodi 17.6

I got an Erorr

18:02:53.351 T:1910853632 ERROR: unable to load:/home/pi/.kodi/addons/skin.audi_rns/PAL16x9/DialogSeekBar.xml, Line 0
Failed to open file
18:02:53.354 T:1910853632 WARNING: Skin has invalid include:…[Verder lezen]

Hi Jeroen,

after the Dynamic Coolant Update, my Coolant shows only 0

Did i have to change something in the new coolant file?

btw my log 🙂

http://minecraftbros.de/log_2_2.txt

Teste some Version that i found:

0.43 = 30 Seconds Wait to Control
0.42 = 30 Seconds Wait to Control
0.40 = 30 Seconds Wait to Control
0.39 = No Version Found to Test
0.38 = Works

Hi Jeroen,
i updatet today to 0.43 but I noticed a little bug,
If i boot up the Pi, i can`t Control the Pi with the RNSE for about 30 Seconds. After the time, its all normal.
Coolant Temperatur are now 0 with ignition off.
So i tryed 0.39 again, works all normal.
0.43 = 30 Seconds Wait to Control

Keep on 🙂

Dave

Hey Jeroen,
Thank you very much that works for me 🙂
No i can work with it.

Did i need to activate some Options to Logging the can or is it activ on default?

Just for info, if my ignition is off the Water Temp in Auto Info shows -17, with ignition its okay.

Sorry for Spam 😀

I found a Bug in 0.38
Every Restart i must set “Block FIS” again.
It doesnt save the state or reset it after a Restart.

If u can Fix this, the skin works Perfect =)

Ok iam back =)

0.38 works too, so the issue was the S1 Feature 🙂

One Little Problem is i hear a lot of “cantalk” Noises out of the Speakers and the Controls are very laggy
If i activate “Block FIS” then its all perfect!

Thank u very much 🙂

oh i didnt see the 0.38 Version. I will try it.

TEST No can-send Version works Perfect.

Hey Jeroen thank u for the quick response,

i installed the whole pi new today, same Problem. No Picture.

Now i tested your NoCan-Send Skin and its works fine, no Picture issue.

But my /home/pi/rnslogs/ is empty.

Can we enable the Cansen step by step to find the wrong canmessage?

Thanks for ur quick Help 🙂

mh okay, if its off by default, this should not be the problem. i will check it tomorrow, some other ideas?