Just an update that might be useful to other users:
In order to set my temperature right, i used the following settings:

#Coolant formula details
Coolant Order : 2
Coolant Amount: -57.2
Coolant Factor : 0.8
#End of Coolant formula details

Best regards, Rui.

Hi Piotr,
My advice is to install the whole solution again.
Install strech with desktop, not the lite one. With the desktop you can copy the lines from the pi webrowser and past them into the terminal. So you will do it a lot faster then tiping by hand.
Follow the tutorial in this site, until the part of “Python can”, instead of doing [pip install…[Verder lezen]

Hi Peter.
I was experiencing that kind of problem, and it was because of the hardpython script.
Please check that when you were setting up the PI, you did not add this lines, because in the full version of the skin they are not needed:

sudo nano /usr/local/lib/python2.7/dist-packages/python_can-1.4.3-py2.7.egg/can/interfaces/interface.py
Last…[Verder lezen]